Bath Accessories Flara Brushed Gold 18" Grab Bar YG0318BG
The Flara Bath suite beautifully blends timeless classics with contemporary flair. The faucet's bold details, clean lines and expressive, gestural flared surfaces combine with slim proportions and a tall, elegant stature for a striking appearance. The Flara Bath suite includes single-handle and two-handle faucet options, matching tub/shower fixtures, a tub-filler faucet, and a broad selection of matching accessories that provides a cohesive look throughout the bath.
Materials: Grab Bar posts and bars are constructed of stainless steel.
Assembled Dimensions : 18" X 2.87" X 3.25
Benefits
-Brushed gold pairs rich, warm tones with lush texturing for a timeless finish
-Supports up to 500 lbs.
-Complies with Americans with Disabilities Act (ADA) specifications
-18" bar length
-1.25" bar diameter
-Corrosion resistant
-Stainless steel construction for added durability
-Limited lifetime warranty
Installation Instructions:
1. Please note that screws MUST be mounted into a wood stud for secure installation.
2. Decide whether you would like to position your grab bar horizontally, vertically or at an angle,
remembering that BOTH ends of the grab bar MUST be positioned over a wood stud (unless using
secure mount anchors).
3. For easier installation and mounting remove 3 set screws from each flange and remove bar from
SecureMount™ Flange.
4. Remove cover and re-assemble flange to bar by tightening 3 set screws.
5. Place grab bar and mark three mounting locations on each of the two grab bar flanges with a pencil.
6. Drill 1/8" diameter pilot holes at each screw location. Make sure to drill into the stud.
7. Install 3 screws and washers each SecureMount™ flange and tighten until secure. If desired, apply
silicone caulk to the back of the SecureMount™ plate to guard against water penetration.
8. After screws are installed each side, dis-assemble bar from SecureMount™ flange by removing
set screws.
9. Re-install covers.
10. Place bar over SecureMount™ flanges and tighten all set screws.
11. Snap on covers.
Showroom Jakarta : Perumahan Alam Sutera, Jl. Jalur Sutera No.23D, RT.002/RW.006, Panunggangan Tim., Kec. Pinang, Kota
Tangerang, Banten 15143
Showroom Surabaya : Jl. Raya Geluran No.28, Geluran, Kec. Taman, Kabupaten Sidoarjo, Jawa Timur 61257
Instagram : @bottegaartisan